Giving you the best use from your Powerpal Hydro Turbine
Low Power Immersion heater elements
ELC2 'Divert mode' load controller
IMMERSION HEATER ELEMENTS
TURBINE LOAD CONTROLLER ELC2
TURBINE LOAD CONTROLLER ELC3
*Standard Insulated copper tank, better insulation will give better performance.
275 Watt, 11" x 2.1/4 screw in with thermstat pocket
550 Watt, 11" x 2.1/4 screw in with thermstat pocket
1kW Watt, 11" x 2.1/4 screw in with thermstat pocket
2kW Watt, 11" x 2.1/4 screw in with thermstat pocket
ELC206S: 650 Watt, use on any PM or synchronous generator
ELC215S: 1500 Watt, use on any PM or synchronous generator
Automatically sends unused power into Domestic Hot Water, air or underfloor electric heating systems and diverts to a second load if the thermostat trips.
Maintains a constant full power load on the turbine regardless of consumer demand with good voltage and frequency stability.
No need to set time switches as power is continuously diverted to the heating loads whenever its not being used elsewhere. At night and in the quiet parts of the day when consumer ation is minimal the turbine pushes energy into the heating.
And a litttle goes a long way .. A 500 Watt element will heat 120 litres of water from 10 to 60C in 18hrs* .. (120 litres is a standard 900x 400 DHW tank)
For use with ELC2 controller, grid mains, generators and other applications
Low power Electric Immersion Heater elements 275W, 550W and 1kW (230ac)
Fits all standard UK Domestic Hot Water tanks (2.1/4"), other fittings to order
Incanoy alloy for all water grades, pressure to 3bar, other types to order.
Immersed length 11" , longer units to order
Thermostat pocket, thermostats to order
Use on 220 - 240 Mains for frost protection, greenhouses, garage and other duties.
Also ideal for wind and solar ac or dc systems
Note these are real HOT water elements specially made for us with a single correctly rated element.